Plastic mixing containers with graduated markings for accurate measurement of materials which are measured by volume. Available in 16 oz. (approx. 473.17 ml), 32oz. (approx. 946.35 ml), 64 oz. (approx. 1892.70 ml) and 165 oz. (approx. 4879.63 ml) sizes. Packaged in cases of 10 or 100 containers.
The Turbine Mixer is a simple design, yet does a better job of mixing Smooth-On rubbers, plastics and foams than any mixer we've tried.It also mixes powder-based Alja Safe® alginate and Matrix NEO® with fiber better than any other mixer. Just as important; it is easier to clean vs other mixers that we've tried saving time and labor. The Turbine Mixer is also less expensive vs. other mixers on the market.
The Kwikee® sprayer is an economical alternative to aerosols for dispensing release agents and sealing agents. It is a faster, labor-saving way to cover large models or molds and delivers sealing agent or release agent in a fine mist.
Dispensing guns hold Body Double®, Dragon Skin®, Ecoflex® and other 400 ml cartridges and forces the Parts A & B through a static mixing tube. Squeeze the handles of the manual gun, pull the trigger on the electric gun. The electric gun is excellent for frequent molders and larger projects.
EZ-Spray® Jr. Spray Gun - The EZ-Spray® Jr. is a versatile, convenient and easy-to-use spray system for spraying moldmaking and casting materials. The EZ-Spray® Jr. gun comes with 1 SMALL tip assembly and 1 LARGE tip assembly.
The following accessories are available for the EZ-Spray® Jr. spray system. EZ-Spray® Jr LARGE Static Mixers (includes Spray Tip) - Static mixers for EZ-Spray® Silicone 20 and EZ-Spray® Silicone 35.
EZ-Spray® Jr SMALL Static Mixers (Includes Spray Tip) - Static mixers for EZ-Spray® STYROCOAT, EZ-Spray® Foam, and EZ-Spray® 45
EZ-Spray® Jr. Large Static Mixer Adapter - This adapter is REQUIRED to use the large static mixers for RED COLORED EZ-Spray® Jr. Gun systems.
Vacuum Chamber For Vacuuming Liquid Rubbers and Liquid Plastics Vacuum systems (vacuum chamber and vacuum pump that pulls 29 inches of mercury) are used to remove the air from high viscosity materials like silicone rubber before pouring. They are also ideal for vacuum degassing liquid plastics (such as Crystal Clear® plastic) for making bubble free castings.
This easy to use vacuum chamber is tough aluminum. The lid is made from shatter resistant acrylic and features a rubber gasket that creates a positive, air tight seal for maximum vacuum.
Inside dimension of vacuum chamber; 14" (35.56 cm) diameter opening x 15" (38.1 cm) tall. . .can accommodate up to a 5 gallon pail.
Easy to read gauge let's you know if your vacuum pump is pulling the required 29" of mercury. Vacuum pump not included.
Versatile Unit for Pressure Casting Liquid Rubber and Liquid Plastics. Pressure casting resins is optimal for creating castings that are truly bubble free. Recommended Pressure for Pressure Casting; 60 psi. Can be pressurized to 80 psi.
E-POX-EE KLEENER® is a unique industrial hand cleaner made especially for removing unreacted liquid epoxy, polyester, urethanes and other resins from the skin. It will also remove liquid paint, lacquer and grease.
Directions for Best Results - DO NOT WET HANDS BEFORE USING 1. Dispense a liberal amount of Kleener onto the hands. 2. Work well into resin contaminated areas. 3. Wash hands with soap and water. 4. Repeat as necessary.
Safety First! For Industrial Use Only - Keep Away From Children