Smooth-On Mold Making and Casting Materials
Home Technical Info How To Frequently Asked Questions Media Gallery News Find a Distributor Mold Makers Directory
McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams
About Us Seminars Tech Support Contact My Account Buy Now Smooth-On Home enews
Material Calculator
and Unit Convertor
Custom Formulating
Newsletter Signup

Get Smooth-On's Greatest Catalog Ever! Click Here
1

                   
What is "cure inhibition"?

Cure inhibition occurs when a surface contaminate prevents a mold rubber from curing as expected.

Experiencing Inhibition When Making A Mold – When making a mold, cure inhibition occurs when contaminants on a model surface prevent the liquid mold rubber from properly curing. While the cured rubber mold may look fine, you will discover that inhibition occurred at the interface between the rubber and the model’s surface. The rubber will be sticky and not fully cured.

For example, applying latex, urethane or silicone rubber directly over a model made of clay containing sulfur will result in cure inhibition. The sulfur in the clay is preventing the rubber from curing. The rubber may appear fine on the outside, but anywhere the rubber touched the clay, it is sticky and will never cure. Remedy: Apply a suitable sealer

Not Allowing A Sealing Agent To Dry or time to “flash off” prior to applying release agent or mixing and applying mold rubber over your model. Remedy: After applying the required number of coats, let your sealing agent dry thoroughly (30 minutes should be enough) before applying release agent (if necessary) or mold rubber.

Be aware; Humidity will affect the evaporation rate of solvents. The more humid the environment, the longer a sealer or sealer / release combination will take to dry. In more humid environments (80% RH), these solvents can take a couple of days to dry or may never dry depending on the solvent.

Also, if you use a solvent based sealer such as shellac or acrylic and then use a liquid release agent over the top of that, the solvent in the liquid release may "re-liquify" the shellac or acrylic and additional time is necessary to let everything dry.

Applying Rubber Into/Over Rubber - Some mold rubbers are not compatible with others. For example, condensation cure silicones will not cure when applied against an addition cure silicone, and vice-versa.

Minimizing Cure Inhibition
– Read the technical data sheet for the products you are using. It should tell you under what circumstances inhibition would occur and what you can do to prevent it. For example, applying a sealing agent to a sulfur clay model before applying mold rubber will prevent cure inhibition in most cases.



The FAQ list is offered as a guideline and offers possible solutions to problems encountered during mold making and casting. No warranty is implied and it is up to the end user to determine suitability for any specific application. Always refer to the provided Technical Bulletins (TB) & Material Safety Data Sheets (MSDS) before using any material. A small scale test is suggested to determine suitability of any recommendation before trying on a larger scale for any application.



Click Here to Submit an FAQ
Smooth-On, Inc. Copyright © 2011
2000 Saint John Street, Easton PA 18042 | Order Desk: 800.762.0744 | Fax: 610.252.6200 | Tech Help: 800.381.1733 or 484.546.0466

E-Commerce Solutions