You’ve made the perfect mold and have just poured Smooth-Cast liquid plastic into the mold to make a reproduction. The plastic cures, and you demold the piece to reveal a casting that looks exactly like the original. Your next step is to paint the casting for outdoor display, but when you try to apply the paint, it beads up on the casting surface and won’t stick.

Urethane plastics can be hard to paint, and there are a number of variables that can affect the outcome. Using a release agent to release the casting from the mold, for example, makes painting a casting almost impossible. Removing release agent from the casting surface can be difficult and is another labor step.

If you are using a urethane rubber mold and casting urethane resin, you must use a release agent to facilitate demold. Using a silicone rubber mold without release agent limits the production life of the mold by 1/2 if you are casting urethane resin.

There are a couple of ways to get the benefits of using a release agent and still have a casting ready for painting following demold.

Powder Coating Technique - Powder coating the mold with Ure-Fil 7, baby powder or talc following the application of a release agent. Here is how it works;

Prior to casting the resin, Ease Release 200 is applied to the mold followed by a powder coating of Ure-Fil 7.

An air hose is used to blow any excess powder from the mold. The urethane resin is then cast into the mold.

The casting comes out of the mold with a dry, matte finish. An auto body primer is applied, followed by an acrylic paint and finally an acrylic sealer. The major advantage to powder coating is that there is no release agent to remove when the casting comes out of the mold. Models can be immediately primed and painted.

Apply Primer To The Mold Surface - The other way is to use a spray primer. Here’s how it works:

Following the application of a release agent, an auto body primer is applied to the mold cavity. Casting resin is then mixed and poured or sprayed. The auto body primer bonds to the casting’s surface and comes out of the mold ready for painting.

Customers contact us regularly asking which primer works best as a foundation for painting their Smooth-On plastic castings. To settle the question once and for all, we tested over 30 aerosol primers and found that most did not work, or worked poorly at best.

The low-quality primer would “bead up” on the surface of the casting.

Whether applied to the rubber mold surface or applied to cured castings (no release agent used), two primers did stand out, providing excellent adhesion and the best for painting.

Plasti-Kote™ Sandable Primer – can be found at Auto Zone and other auto supply stores in the U.S. Contact: Plasti-Kote in Medina, OH Tel. 800 431 5928 or www.plasti-kote.com

Bulldog™ Adhesion Promoter - Contact: W.M. Barr Co. in Memphis, TN Tel. 800 398 3892 or www.wmbarr.com. Or order online at www.levineautoparts.com

• Ease Release® 200