TASK® 7 Flame Out® is a low viscosity, fast set flame resistant plastic ideal for making fire resistant prototype and architectural models, model toys, theme park and stage elements, durable miniatures and special effect props. Flame Out® can also be used as a fire retardant potting and encapsulation compound.
Flame Out® does not contain mercury, TDI or MOCA. Mix ratio is 1A:1B by volume. Pot life is 2.5 min. and demold time is 10 min. at 73°F / 23°C (depending on mass). Fully cured Flame Out® material is tough, durable, machinable and paintable. It resists moisture and mild solvents. Vibrant colors and color effects are possible by adding SO-Strong® color tints.
More information about TASK® 7 Flame Out®:
1 - The mold is properly prepared and leveled prior to measuring material.
2 - TASKŪ 7 Flame OutŪ is a two-component urethane resin that is mixed 1A:1B by volume.
3 - Part A is dispensed.
4 - An equal volume of Part B is dispensed.
5 - TASKŪ 7 Flame OutŪ is mixed 1A:1B by volume.
6 - Part A is poured into a mixing container.
7 - Part B is added to the mixing container.
8 - Parts A and B are thoroughly mixed. Care is taken to scrape the sides and bottom of the container while mixing. TASKŪ 7 Flame OutŪ has a pot life of 2.5 minutes.
9 - TASKŪ 7 Flame OutŪ is poured into the prepared mold.
10 - Allow TASKŪ 7 Flame OutŪ to cure. Cure time is 10 minutes at 73° F / 23°C
11 - The cured casting is slowly peeled away from the mold.
12 - The cured TASKŪ 7 Flame OutŪ casting.
13 - The casting reflects perfect detail from the mold.
14 - TASKŪ 7 Flame OutŪ meets UL 94 V-O requirements for flame resistance.
15 - TASKŪ 7 Flame OutŪ self extinguishes once the ignition source is removed.