Compare Tool

Vs.
remove

Mold Star™ 19T

EZ-Spray® Silicone 22 vs. Mold Star™ 19TEZ-Spray® Silicone 22

1A:1B Mix By Volume Platinum Silicone Rubber

 View Product

Add Material to Compare

start over

Key Differences

Pot Life5 minutes3 minutes
Cure Time45 minutes12 minutes
ColorTranslucent GreenTranslucent
Elongation @ Break450 %740 %
Disclaimer
Although we do our best to ensure the accuracy of this Compare Tool, Smooth-On offers no warranty either expressed or implied as to the reliability of the information contained herein. Smooth-On assumes no liability for loss or damage associated with use of the Compare Tool. If this is a critical project, we encourage you to review all of the technical data below and contact our Technical Service department with any questions or concerns.

All Technical Data

EZ-Spray® Silicone 22Mold Star™ 19T
Product Type
  • Silicone Rubber - Platinum Cure
  • Silicone Rubber - Platinum Cure
Mixed Viscosity11,000 cps11,000 cps
Mix Ratio By Volume1A:1B1A:1B
Mix Ratio By Weight1A:1B
Pot Life5 minutes3 minutes
Cure Time45 minutes12 minutes
Shore A Hardness2219
Specific Gravity1.08 g/cc1.08 g/cc
Specific Volume25.6 cu. in./lb.25.6 cu. in./lb.
ColorTranslucent GreenTranslucent
Die B Tear Strength102 pli90 pli
Tensile Strength490 psi420 psi
Elongation @ Break450 %740 %
100% Modulus49 psi
Shrinkage<.001 in. / in.0.001 in. / in.
Useful Temperature (min)-65 °F-65 °F
Useful Temperature (max)500 °F450 °F

Product Description

EZ-Spray® Silicone 22

EZ~Spray® Silicone 22 are sprayable silicones which cure quickly to soft rubbers with high elongation and tear strength. Liquid silicone is sprayed through the EZ~Spray® Junior Cartridge System which is an economical alternative to expensive spray equipment. After a suitable thickness is attained, EZ~Spray® Silicone 22 cures in about 45 minutes. EZ~Spray® Silicone cures with negligible shrinkage to strong, durable silicone rubbers good for production casting of polyester, epoxy or urethane resins, gypsum, concrete and other materials.

Read More

Mold Star™ 19T

Mold Star™ 19T is an easy to use Shore 19A translucent platinum silicone that is mixed 1A:1B by volume (no weighing scale necessary). It features a relatively low viscosity and vacuum degassing is not required for most applications. Pot life is 3 minutes and cure time is 12 minutes at room temperature.

Read More

Select a Material from a Category Below

Silicone Rubber - Tin Cure ›

Silicone Rubber - Platinum Cure ›

Urethane Rubber ›

Polysulfide Rubber ›

Urethane Resins ›

Epoxy Casting and Laminating Resins ›

Epoxy Putties ›

Epoxy and Urethane Coatings ›

Mix and Pour Expanding Foams ›

Adhesives ›

Lifecasting Materials ›

Skin Safe FX Materials ›

Polymer Modifiers for Concrete and Gypsum ›