Compare Tool

Vs.
remove

Encapso™ K

Encapso™ K vs. EZ-Spray® Silicone 22EZ-Spray® Silicone 22

Water Clear Encapsulation / Display Rubber

 View Product

Add Material to Compare

start over

Key Differences

Mixed Viscosity11,000 cps150 cps
Pot Life5 minutes120 minutes
Cure Time45 minutes16 hours
Shore A Hardness2233
ColorTranslucent GreenClear
Disclaimer
Although we do our best to ensure the accuracy of this Compare Tool, Smooth-On offers no warranty either expressed or implied as to the reliability of the information contained herein. Smooth-On assumes no liability for loss or damage associated with use of the Compare Tool. If this is a critical project, we encourage you to review all of the technical data below and contact our Technical Service department with any questions or concerns.

All Technical Data

EZ-Spray® Silicone 22Encapso™ K
Product Type
  • Silicone Rubber - Platinum Cure
  • Silicone Rubber - Platinum Cure
Mixed Viscosity11,000 cps150 cps
Mix Ratio By Volume1A:1B1A:1B
Mix Ratio By Weight1A:1B
Pot Life5 minutes120 minutes
Cure Time45 minutes16 hours
Shore A Hardness2233
Specific Gravity1.08 g/cc0.97 g/cc
Specific Volume25.6 cu. in./lb.28.6 cu. in./lb.
ColorTranslucent GreenClear
Die B Tear Strength102 pli
Tensile Strength490 psi
Elongation @ Break450 %
100% Modulus49 psi
Shrinkage<.001 in. / in.0.001 in. / in.
Useful Temperature (min)-65 °F
Useful Temperature (max)500 °F
Dielectric Constant, 100Hz3.17

Product Description

EZ-Spray® Silicone 22

EZ~Spray® Silicone 22 are sprayable silicones which cure quickly to soft rubbers with high elongation and tear strength. Liquid silicone is sprayed through the EZ~Spray® Junior Cartridge System which is an economical alternative to expensive spray equipment. After a suitable thickness is attained, EZ~Spray® Silicone 22 cures in about 45 minutes. EZ~Spray® Silicone cures with negligible shrinkage to strong, durable silicone rubbers good for production casting of polyester, epoxy or urethane resins, gypsum, concrete and other materials.

Read More

Encapso™ K

Encapso™ K is a water clear encapsulation rubber that looks just like water and is ideal for a variety of encapsulation and display applications.

How Does Encapso™ K Work? – Two clear liquids (Part A and Part B) are mixed together in equal amounts. The mixture is then poured around artificial flower stems or over an object. Encapso™ K cures to a soft rubber over night depending on casting thickness and conditions. When cured, Encapso™ K looks just like water and will last a long time.

Read More

Select a Material from a Category Below

Silicone Rubber - Tin Cure ›

Silicone Rubber - Platinum Cure ›

Urethane Rubber ›

Polysulfide Rubber ›

Urethane Resins ›

Epoxy Casting and Laminating Resins ›

Epoxy Putties ›

Epoxy and Urethane Coatings ›

Mix and Pour Expanding Foams ›

Adhesives ›

Lifecasting Materials ›

Skin Safe FX Materials ›

Polymer Modifiers for Concrete and Gypsum ›