Compare Tool


Mold Star™ 30

Mold Star™ 30 vs. EZ-Spray® Silicone 22EZ-Spray® Silicone 22

1A:1B Mix By Volume Platinum Silicone Mold Rubber

 View Product

Add Material to Compare

start over

Key Differences

Pot Life5 minutes45 minutes
Cure Time45 minutes6 hours
ColorTranslucent GreenBlue
Elongation @ Break450 %339 %
100% Modulus49 psi96 psi
Although we do our best to ensure the accuracy of this Compare Tool, Smooth-On offers no warranty either expressed or implied as to the reliability of the information contained herein. Smooth-On assumes no liability for loss or damage associated with use of the Compare Tool. If this is a critical project, we encourage you to review all of the technical data below and contact our Technical Service department with any questions or concerns.

All Technical Data

EZ-Spray® Silicone 22Mold Star™ 30
Product Type
  • Silicone Rubber - Platinum Cure
  • Silicone Rubber - Platinum Cure
Mixed Viscosity11,000 cps12,500 cps
Mix Ratio By Volume1A:1B1A:1B
Pot Life5 minutes45 minutes
Cure Time45 minutes6 hours
Shore A Hardness2230
Specific Gravity1.08 g/cc1.12 g/cc
Specific Volume25.6 cu. in./lb.24.7 cu. in./lb.
ColorTranslucent GreenBlue
Die B Tear Strength102 pli88 pli
Tensile Strength490 psi420 psi
Elongation @ Break450 %339 %
100% Modulus49 psi96 psi
Shrinkage<.001 in. / in.<.001 in. / in.
Useful Temperature (min)-65 °F-65 °F
Useful Temperature (max)500 °F450 °F

Product Description

EZ-Spray® Silicone 22

EZ~Spray® Silicone 22 are sprayable silicones which cure quickly to soft rubbers with high elongation and tear strength. Liquid silicone is sprayed through the EZ~Spray® Junior Cartridge System which is an economical alternative to expensive spray equipment. After a suitable thickness is attained, EZ~Spray® Silicone 22 cures in about 45 minutes. EZ~Spray® Silicone cures with negligible shrinkage to strong, durable silicone rubbers good for production casting of polyester, epoxy or urethane resins, gypsum, concrete and other materials.

Read More

Mold Star™ 30

Mold Star™ mold rubbers are easy to use platinum silicones which are mixed 1A:1B by volume (no weighing scale necessary). Mold Star™ silicones feature relatively low viscosities and vacuum degassing is not required for most applications. Mold Star™ 30 is a harder material, with a 30A Shore hardness.

Read More

Select a Material from a Category Below

Silicone Rubber - Tin Cure ›

Silicone Rubber - Platinum Cure ›

Urethane Rubber ›

Polysulfide Rubber ›

Urethane Resins ›

Epoxy Casting and Laminating Resins ›

Epoxy Putties ›

Epoxy and Urethane Coatings ›

Mix and Pour Expanding Foams ›

Adhesives ›

Lifecasting Materials ›

Skin Safe FX Materials ›

Polymer Modifiers for Concrete and Gypsum ›