Mixed Viscosity | 1,200 cps | 1,800 cps |
Pot Life | 13 minutes | 50 minutes |
Cure Time | 24 hours | 16 hours |
Shore A Hardness | 80 | 60 |
Color | Translucent | Off White |
Die C Tear Strength | 77 pli | 132 pli |
Elongation @ Break | 127 % | 581 % |
100% Modulus | 670 psi | 256 psi |
Econ™ 80 | ReoFlex™ 60 | |
---|---|---|
Product Type |
|
|
Mixed Viscosity | 1,200 cps | 1,800 cps |
Mix Ratio By Volume | 1A:1B | 1A:1B |
Mix Ratio By Weight | 100A:90B | 1A:1B |
Pot Life | 13 minutes | 50 minutes |
Handling Time | 6 hours | — |
Cure Time | 24 hours | 16 hours |
Shore A Hardness | 80 | 60 |
Specific Gravity | 1.06 g/cc | 1.04 g/cc |
Specific Volume | 26.16 cu. in./lb. | 26.7 cu. in./lb. |
Color | Translucent | Off White |
Die C Tear Strength | 77 pli | 132 pli |
Tensile Strength | 955 psi | 782 psi |
Elongation @ Break | 127 % | 581 % |
100% Modulus | 670 psi | 256 psi |
Shrinkage | 0.0014 in. / in. | <.001 in. / in. |
Econ™ 80 is an economical Shore 80A urethane rubber suitable for a variety of mold making and industrial applications. It is a lower cost, faster cure alternative to our popular PMC™-780. Physical properties are lower vs. PMC™-780. This is a no odor system that features a 1A:1B mix ratio and a low viscosity for easy mixing and pouring. Working time is about 13 minutes at room temperature, handling time is 6 hours and rubber cures overnight. Econ™ 80 is translucent and easily colored with SO-Strong™ or Ignite™ colorants. Econ™ 80 is used to make short run molds for casting concrete and resins, concrete stamping pads, rubber mechanical parts, coating fabrics, pour-in-place gaskets for industrial equipment and burial vaults. Important: To minimize air bubbles in cured rubber, vacuum degassing is recommended.
FOR COMMERCIAL/INDUSTRIAL USE ONLY
ReoFlex™ urethane rubbers offer superior physical and performance properties for production casting of wax, plasters, and resins. ReoFlex™ urethanes are available in 20A, 30A, 40A, 50A and 60A Shore hardnesses and feature convenient one-to-one by volume mix ratios. Vacuum degassing is not necessary and ReoFlex™ rubbers cure with negligible shrinkage to a durable rubber that will last in production. ReoFlex™ “Wet” rubbers will shrink somewhat over time vs. “Dry” formulations.
ReoFlex™ mold rubbers are used for a variety of applications including making molds to reproduce sculpture and architectural elements, as well as for making special effects, toys and prototypes. Vibrant colors can be achieved by adding So-Strong™ Color Tints, available from Smooth-On.
Casting Concrete? Look into the VytaFlex™ series of urethane mold rubbers. VytaFlex™ urethanes were formulated specifically for casting concrete / pigmented concrete and feature Smooth-On’s exclusive ‘V-Polymer™’ technology.
FOR COMMERCIAL/INDUSTRIAL USE ONLY