How To Make a Star Trek Klingon Disruptor with Mold Max™ Silicone and Smooth‑Cast™
Step 4: Dispensing and Pouring Mold Max 15T
Dispense Mold Max 15T part A and B into a mixing bucket. The Mold Max 15T silicone should be mixed with a squirrell mixer on an electric drill. After the material is mixed it needs to be vacuumed to remove excess air. Once this is complete, pour the Mold Max 15T into the mold box in a thin stream. The Mold Max 15T will flow up and over the gun and then it should be left to cure overnight (16 hours) at room temperature (73F/23C).
